Ball Mill Routine Maintenance Can Extend Its life

zhuoyachina's Avatar


02 Feb, 2015 06:54 AM

For ball mill, there are many kinds in current market such as overflow ball mill, ultrafine ball mill and other types. However, these traditional ball mill can not satisfy the customers' needs with the development of society any longer because of their low technology level. Under this circumstance, energy-saving ball mill emerges as the time requires. Different ores and stone materials can satisfy different production needs after being crushed. In the process of sand production, the grinding is a critical step. Therefore, ball mill becomes an important part in the whole process.

Although ball mill can operate continuously, the daily maintenance of it is more important because it can influence the working efficiency and service life directly. The following aspects are what we need to pay special attention:

1.After one month's operation, it should give off the lubrication oil and change new oil. In addition, the temperature of the main bearing oil should be under 55℃.

2.If there is abnormal noise during the process of operation, it should stop to check and remove the faults at once.

3.It should check the chain, chain wheel and bearings as often as possible and it should deal with the problems if there is any.

4.It should change the main bearing, scaleboard bolt, grid board and mill board if there is severe abrasion on these parts in avoid that they will effect the normal work of the ball mill.

In fact, all the above are only some suggestions to the maintenance of ball mill and every customer should pay special attention to the safe operation of the machine. Except for ball mill, we also supply raymond mill, vertical mill and other grinding mills which also need careful maintenance during operation.

  1. zhuoyachina closed this discussion on 02 Feb, 2015 06:54 AM.

Comments are currently closed for this discussion. You can start a new one.

Keyboard shortcuts


? Show this help
ESC Blurs the current field

Comment Form

r Focus the comment reply box
^ + ↩ Submit the comment

You can use Command ⌘ instead of Control ^ on Mac